Will Heating and Plumbing Be Affected by one specific Slowing Economy?

Your water heater is one rather used and costly appliances in your home, and consumes a large portion of your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving on your home heating as well as costs.

Regular flushing of one’s water heater is considered the single most important step you consider to prolong its service life in addition, it save energy. For time, sediments enhance in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not merely destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most regions of the country, the typical water heater lasts 3-5 years. Regularly flushing your water heater can double the life of your water heater from 3-5 to 7-10 years. Device costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is a must in today’s economy. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs in half. Depending on the volume of warm water your home uses, that can mean a savings of $20 to over $50 a month.

To drain your water heater, on the internet should set the thermostat to pilot (if it is a gas water heater) or turn the circuit breaker off (if it is actually electric heater). Failure to do so could result in overheating and severe damage to the actual heater. Next, close the water supply valve located more than a water inlet line going into your water heater. You may then connect a hose to the drain valve located towards the end of the space heater. Open the drain and allow it to play until all for the water has emptied from the heating unit. Then close the drain. Open the water supply valve and refill the hot water heater. You should also open a hot water faucet somewhere inside the house and stand there and watch it run for several minutes until the water flows out gradually. This will allow air to vent off of the heater and the hot water lines. Finally, you can turn the thermostat for you to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your property to filter or condition the water so may less corrosive to your plumbing system, particularly in areas which have hard this type of water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in location to discuss options and products to be fitting.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2

Bookmark the permalink.